BPRLW - AEROSOL SPRAY PAINT GRAY 36440

  • MSDS: BPRLW
  • Manufacturer: PLASTI KOTE COMPANY INC
  • Product Name: AEROSOL SPRAY PAINT GRAY 36440
  • National Stock Number: 8010-00-935-7085
Product Identification

Product ID:AEROSOL SPRAY PAINT GRAY 36440
MSDS Date:01/31/1990
FSC:8010
NIIN:00-935-7085
MSDS Number: BPRLW

Responsible Party
PLASTI-KOTE COMPANY, INC.
1000 LAKE RD.
MEDINA, OH 44256
US

Emergency Phone: 216-725-4511

Info Phone: 216-725-4511

Cage: DO534

Contractor
TEMPO PRODUCTS CO A PLASTI-KOTE CO INC
MEDINA, OH 44256 US

Telephone: 330-725-4511

Cage: 07708

Ingredients

NO INGREDIENT FOR THIS FORMULATION_INGREDIENT

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:INHALE: EXCESSIVE INHALATION OF VAPORS
CAN CAUSE NASAL/RESPIRATORY
IRRITATION/DIZZINESS/WEAKNESS/FATIGUE/NAUSEA/HEADACHE/POSSIBLE
UNCONSCIOUSNESS/ASPHYXIATION. EYE: SEVERE
IRRITATION/REDNESS/TEARING/B LURRED VISION. INGEST:
GASTROINTESTINALIRRITATION/NAUSEA/VOMITING/DIARRHEA. SKIN:
IRRITATION FOR SOME PERSONS. ***
Explanation of Carcinogenicity:METHLENE CHLORIDE SUSPECTED CARCINOGEN.
Effects of Overexposure:***REPORTS ASSOCIATE REPEAT/PROLONG
OCCUPATIONAL OVEREXPOSURE TO SOLVENTS W/PERMANENT BRAIN/NERVOUS
SYSTEM DAMAGE. SEVERE OVEREXPOSURE IN LAB AMINALS HAS ALSO CAUSED
LIVER ABNORMALITIES/DAMAGE TO KIDN EYS/LUNGS/SPLEEN. INTENTIONAL
MISUSE BYDELIBERATELY CONCENTRATING AND INHALING THE CONTENTS MAY
BE HARMFUL OR FATAL.
Medical Cond Aggravated by Exposure:CAN CAUSE ALLERGIC RESPIRATORY/SKIN
REACTIONS.

First Aid

First Aid:INHALE: MOVE TO FRESH AIR. OXYGEN/ARTIFICIAL RESPIRATION AS
NEEDED. SEEK MEDICAL HELP. EYE: FLUSH W/WATER 15 MINUTES,
OCCASIONALLY LIFT LIDS. GET MEDICAL ATTENTION. INGEST: DO NOT
INDUCE VOMITING. (AS PIRATION OF MATERIAL INTO LUNGS CAN CAUSE
CHEMICAL PNEUMONITIS-FATAL. KEEP PERSON WARM/QUIET. GET MEDICAL
ATTENTION/POISON CONTROL CENTER. SKIN: WASH W/SOAP/WATER/VARIOUS
HAND CLEANERS/WASH CLOTHES.

Fire Fighting

Flash Point:NR
Lower Limits:1
Extinguishing Media:"ALCOHOL" FOAM, CARBON DIOXIDE, DRY CHEMICAL
Fire Fighting Procedures:WATER SPRAY INEFFECTIVE-USED TO COOL CLSD
CNTNRS-PREVENT PRESSURE
BUILD-UP/AUTOIGNITION/EXPLOSION-EXPOSED-EXTREME HEAT. FOG NOZZLE.
SCBA/FULL FACEPIECE, *
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS
EXPLODE/AUTOIGNITE-EXPOSED-EXTREME HEAT. VAPORS HEAVIER THAN
AIR-TRAVEL ALONG GROUND/VENTILATION MOVED/IGNITED BY PILOT
LIGHTS/FLAMES/SPARKS**

Accidental Release

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCES. VENTILATE
AREA. ABSORB LIQUID ON PAPER/VERMICULITE/FLOOR ABSORBENT/OTHER AND
TRANSFER TO CLOSED CONTAINER.

Handling

Handling and Storage Precautions:DO NOT STORE IN AREAS ABOVE 120F OR IN
DIRECT SUNLIGHT, OR NEAR HEAT OR OPEN FLAMES. DO NOT PUNCTURE OR
INCINERATE.

Exposure Controls

Respiratory Protection:CASUAL/OCCASIONAL USE: AVOID INHALING
VAPORS/SPRAY MIST/OPEN WINDOWS/DOORS/ENSURE FRESH AIR ENTRY DURING
APPLICATION/DRYING. IF EYE WATERING/HEADACHES/DIZZINESS IS
EXPERIENCED: INCREASE FRESH AIR/WEAR RESPIRATORY PROTECTION/LEAVE
AREA.
Ventilation:REGULAR/CONTINUOUS USE: PROVIDE SUFFICIENT MECHANICAL
(GENERAL)/LOCAL EXHAUST VENT TO MAINTAIN EXPOSURE BELOW TLV'S.
Protective Gloves:CHEMICAL RESISTANT SUCH AS NEOPRENE
Eye Protection:CHEMICAL SPLASH GOGGLES-OSHA REGS
Other Protective Equipment:WHERE SPECIAL OR UNUSUAL CONDITIONS EXIST
THE EXPERT ASSISTANCE OF AN INDUSTRIAL HYGIENIST SHOULD BE SOUGHT.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING WASHROOM. AS
WITH ALL CHEMICALS, MINIMIZE PERSONAL CONTACT/BREATHING OF VAPORS.
Supplemental Safety and Health

Chemical Properties

HCC:V3
Boiling Pt:B.P. Text:104 TO 331F
Melt/Freeze Pt:M.P/F.P Text:1500 F MIN
Vapor Density:>AIR
Spec Gravity:<1 (WATER=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:SLIGHT TO MODERATE
Appearance and Odor:TYPICAL SOLVENT PAINT
Percent Volatiles by Volume:85-90

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS AND HEAT. *OPERATED IN PRESSURE DEMAND/OTHER
POSITIVE PRESSURE MODE.
Stability Condition to Avoid:HEAT, SPARKS, OPEN FLAME
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS, CARBON
DIOXIDE/CARBON MONOXIDE, VARIOUS HYDROCARBONS, NITROGEN COMPOUNDS,
ETC, WHEN BURNED.

Disposal

Waste Disposal Methods:MATERIAL COLLECTED ON ABSORBENT MATERIAL MAY BE
DEPOSITED IN A POSTED TOXIC SUBSTANCE LANDFILL IN ACCORDANCE
W/LOCAL, STATE AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.